![]() Normally you use channel 5 of the radio (AUX 1 in BetaFlight) for this. You probably have a radio channel dedicated to the task of arming and disarming the drone. ![]() ![]() This type of command is dangerous and should be avoided at all costs. Note: If you arm your drone using lever (throttle lever down and right), swap immediately by a switch command. I will detail each of these problems: The arming command is not being recognized by the flight controller The accelerometer has never been calibrated.The arming command is not being recognized by the flight controller (radio switch or command on the levers).The drone will not arm only in the following situations: If you have an APM, Naza, OpenPilot, LibrePilot or any other that does not run BetaFlight or CleanFlight, this article is not for you. This article is intended only for drones that use BetaFlight or CleanFlight flight controllers. I will demonstrate below the main causes and how to solve. Usually this happens for some simple to solve problem. A very common problem when you are a beginner is to not be able to make the drone arm.
0 Comments
Leave a Reply. |